Long-distance Touch Lamps might seem like cutting-edge technology, but they are actually incredibly simple, even a young child can figure out how to use one in minutes. To get started, you need to plug in the Touch Lamp. Most models come with a standard European plug that ranges from 85V to 265V, though they can be used in other regions of the world with the proper adapter. If you don’t have a standard European plug, you can purchase a special plug that works with 85V-265V.
Disadvantages of touch-sensitive lamps
One of the most convenient inventions ever, touch-sensitive lamps allow you to control their on-off function with a simple touch. They have become so popular that they have even been recalled. Although these lamps are convenient, some of their disadvantages may outweigh their benefits. Listed below are some of the common disadvantages of touch-sensitive lamps. Read on to learn about these problems and learn how to overcome them.
Compared to normal light switches, touch-sensitive lamps have only three brightness levels. They don’t utilize three-way bulbs, but instead use duty cycles that vary the amount of power supplied to the bulb. In contrast, a normal light switch provides full power, which causes a rapid decrease in the brightness of the bulb. As a result, this is not a good option for a bedroom or living room.
Moreover, you should consider the size of the touch lamp. Generally, these devices are measured in Lumens, and the higher the Lumens, the brighter the light. However, you may not need a bright light in your bedroom. You can buy a smaller touch-sensitive lamp if you want to put it on your desk. If you plan to buy a larger touch lamp, make sure you measure the space for it before you make the purchase.
How to clean a touch-sensitive lamp
If you have a touch-sensitive lamp in your home, you may be wondering how to clean it. You should be aware of certain safety tips when you clean touch-sensitive lamps. The first step is to unplug them from their wall-dimmer outlets. Do not plug them into the light switch itself, as this can damage the bulb. Instead, disconnect the lamp’s wires from the touch-control, and then solder a new one into place.
Another way to clean touch-sensitive lamps is by removing the bulb. Most touch-sensitive lamps depend on a body’s capacitance, which means that it holds electrons. When you touch the lamp, more electrons will flow into the circuit, and this helps the lamp to stay lit. You can purchase a touch-sensitive lamp apparatus at any home improvement store. Make sure to follow the manufacturer’s instructions.
In some cases, the filament of a touch lamp has broken. In such a case, you must replace it. If the touch lamp still works, you can use an incandescent light bulb to test its functionality. A compact fluorescent light bulb will work, but only if it is labeled dimmable. When you’ve finished repairing the touch-sensitive lamp, replace the light bulb. You can also replace the cord.
How to replace the sensor wires on a touch-sensitive lamp
How to replace the sensor wires on if your touch-sensitive lamp is no longer functioning? The first step is to unscrew the connectors attached to the touch sensor. Then, unplug the white, red, and grey wires that run from the touch sensor. The yellow wire of the sensor should connect to a nipple on the base of the lamp. Tighten the nut on the yellow wire with pliers. Next, replace the bottom of the touch panel and the fuse.
Once the wiring is disconnected, unscrew the ring terminal. The wires connect to the touch-sensitive switch through the metal part of the lamp. The wires connecting the touch-sensitive switch and the metal part are attached to a small wire. Unscrew the locknut to remove the connector. Carefully slide the lamp’s other two wires onto the white touch-control wire.
If the metal on the touch panel is damaged, the lamp will not work. It could be a worn-out touch panel or a damaged thyristor. Electrical surges can fry these components, making them non-responsive. A damaged thyristor controls the lamp’s off-and-on functionality. Likewise, a damaged thyristor will cause the lamp to remain on.